This release provides stability improvements to the PPR data recording, such that software issues and freezes will not interrupt data recording. It also provides the option of "one point calibration" for system inputs.
IMPORTANT: Updating to 9.0.32 may take up to 1 hour. Please do not disconnect the power while the system is updating.
Known Issues:
#1519
For some inputs, the dampening value may be reset to 0 during the update to v9.0. After performing the update, check the value and if it is not correct, set it and save the configuration.
#1463
The system does not send notifications to the "Record Gap Notification" page in Legendary.
#1362
If the screen freezes, it may take 10 minutes to recover the frozen screen. Data recording will continue during the freeze and recovery process.
#1467
Firmware versions are not sent to Legendary.
#1539
The alarm setpoint values shown on the Alarm Status page may be inaccurate for Universal Inputs. The correct values are shown on the configuration pages for the individual alarms. The correct values are stored in the system, so the behavior of the alarms is correct, the issue only affects how they are displayed to the user.
#1481
The first time the Date & Time screen is opened, the time and time zone displayed may be incorrect. Syncing the time and setting the time zone resolves the issue.
#1497
New users don't appear in the Users list until the page is closed and reopened.
#1498
The buttons on the calibration screen can become unresponsive. If this occurs, close and reopen the page. If the issue persists, it can be resolved by power cycling the system.
#1500
One point calibration doesn't show a popup when the calibration is saved.
#1503
A "failed to update the system time" popup may appear. The system’s time will be unchanged, and it can be closed and ignored.
Copyright © 2022 Anderson-Negele